The fire table below has a propane burner and is not configured correctly. That is why you will see soot (carbon monoxide) the black stuff on the glass. If you purchased a table from one of these clowns that have you connect a propane tank to a burner ring, you will have problems. We use all the proper safety valves and air mixers to insure a clean and safe burn. See our propane page. We are the only company manufacturing a propane burner that is safe and built correctly for these fire tables when you are using our glass. The glass used was Starfire Base Glass and Pale Blue Topper. Since and after the install we did supply the correct burner and it is burning clean as it should be.
As you can see after burning for about 10 minutes the soot is and will be an issue. Carbon monoxide IS NOT GOOD FOR YOU!
The fireplace below is in San Diego, California and the colors used were:
The fireplace below belongs to Ross Barnett in Florida. This was a ventless propane installation. Ross built a front wave design and we built a special wedge pan with the controls underneath. This is a remote control ventless burner. Great job Ross! The glass that was uses was:
and below is the wave before out ventless burner was installed.
What makes us different from anyone else is that we allow you to exercise your imagination. If you see it, dream it, draw it, imagine it we can build it for you. Ross saw what we did for other customers and he came up with this very cool design for us to build for his family room, thanks Ross!
What make us different from anyone else is what we offer you as a selection. We offer hundreds of colors, sizes, textures, variations, categories and more importantly we set the standard which everyone else can only try to imitate us. We welcome your comments and suggestions so please send us your comments.Imitation is the highest form of flattery, thank you.
We built a double box to protect the equipment in the fire pit as well
The ring is now installed
The electronics can be accessed if ever there was a failure of the equipment and you can access it from the surface. Before the equipment was 20 inches below the surface, not a very good idea!
As you have looked at all of our pictures we would like you to know we use Crystals as our Toppers and Toppings. We don't use "Recycled" glass, ever! We are actually the only company that produces Crystals for fireplace and fire pits.
We tried to get pictures of it burning, but the flames just didn't show. Look above and you can see a flicker in the daylight. Actually the flames were over 16" tall but you can't see this in daylight.The contractor will get a few night pictures when they and if they can.
The burner below is one of our FPPK's (fire pit propane kit). With this FPPK we set it up for Black Magic! This was table tested for the pictures. Hopefully the customer will send us pictures after and during installation. We first sent these pictures for the customers approval. Here you go! The pan below belongs to Scott Spector and he finally installed the fire pit in his back yard, WOW, one really nice backyard!
As you can see around the lower edges it was leaking and yes we did fix this.
The fire pit below was built by Scott Spector in Florida. He started with an FPPK 30 which includes a 30" base plate and a double 24" stainless steel ring. Here we go from the beginning:
The propane line was run/ installed under the pavers.
and our FPPK 30". That is our 30" propane burner. You can see the actual burner above burning before shipment and installation.
We don't have any pictures of the fire pit burning at Scott's but he did tel us that when he fired it up again he would try to send us a few pictures. Thanks Scott.